英文字典,中文字典,查询,解释,review.php


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       


安装中文字典英文字典辞典工具!

安装中文字典英文字典辞典工具!










  • Refer to the exhibit. Which default static route command would allow R1 . . .
    Question: Refer to the exhibit Which default static route command would allow R1 to potentially reach all unknown networks on the Internet?
  • CCNA 2 v7 Modules 14 - 16: Routing Concepts and . . . - ITExamAnswers
    An administrator is attempting to install a default static route on router R1 to reach the Site B network on router R2 After entering the static route command, the route is still not showing up in the routing table of router R1
  • CCNA 2 (v5. 0. 3 + v6. 0) Chapter 2 Exam Answers 2020 – 100% Full
    Static routing can also be more secure because it does not advertise over the network 2 Refer to the exhibit What routing solution will allow both PC A and PC B to access the Internet with the minimum amount of router CPU and network bandwidth utilization? Configure a static route from R1 to Edge and a dynamic route from Edge to R1
  • CCNA 2 Chapter 6 v5. 0 Exam Answers 2015 (100%)
    Which default static route command would allow R1 to potentially reach all unknown networks on the Internet? Which two statements describe classful IP addresses? (Choose two ) A company has several networks with the following IP address requirements: IP phones – 50 PCs – 70 IP cameras – 10 wireless access points – 10 network printers – 10
  • CCNA 2 (v5. 0. 3 + v6. 0) Chapter 6 Exam Answers 2020 – 100% Full
    The network administrator needs to configure a default route on the Border router Which command would the administrator use to configure a default route that will require the least amount of router processing when forwarding packets?
  • CCNA 2 Chapter 6 v5. 0 Exam Answers 2015 (100%)
    o Static routing uses fewer router resources than dynamic routing o Static routing is relatively easy to configure for large networks 2 Refer to the exhibit Which is the best way for PC A and PC B to successfully communicate with sites on the Internet? 3 o Configure a static route from R1 to ISP and a dynamic route from ISP to R1
  • Refer to the exhibit. What command would be used to configure a static . . .
    Explanation: To configure an IPv6 static route, use the ipv6 route command followed by the destination network Then add either the IP address of the adjacent router or the interface R1 will use to transmit a packet to the 2001:db8:1:4:: 64 network
  • Refer to the exhibit. Which static route command can be entered on R1 . . .
    IT Questions Bank › Refer to the exhibit Which static route command can be entered on R1 to forward traffic to the LAN connected to R2? Question: Refer to the exhibit Which static route command can be entered on R1 to forward traffic to the LAN connected to R2? ipv6 route 2001:db8:12:10:: 64 S0 0 0 ipv6 route 2001:db8:12:10:: 64 S0 0 1 fe80::2


















中文字典-英文字典  2005-2009