英文字典,中文字典,查询,解释,review.php


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       


安装中文字典英文字典辞典工具!

安装中文字典英文字典辞典工具!










  • Orca Slicer settings for temps? : r 3Dprinting - Reddit
    One week into 3D printing and I'm moving from Cura to Orca I ran a couple of prints and it feels and looks great but I can't find anywhere to set the bed temp within Orca I let it build gcode for Benchy and the bed was set to 45c, then it failed I re-ran the same gcode and manually set the bed to 60c and it stuck much better Would like to make that a standard for my Ender 3 V3 SE Any advice?
  • Post Processing gcode for Timelapse : r OrcaSlicer - Reddit
    I'm looking for information on how to insert Post Processing gcode before each layer change in Orca I need to be able to insert TIMELAPSE_TAKE_FRAME so that it occurs before each layer change so Klipper knows to take a time-lapse frame each layer change Any help would be greatly appreciated
  • Whats peoples opinion on Orca vs Prusa slicer? : r 3Dprinting
    Orca slicer is a fork of bambu slicer which is a fork of prusaslicer from what I have read I have only used prusaslicer but judging by screenshots they're similar
  • How do I fill these gaps? : r OrcaSlicer - Reddit
    1 8K subscribers in the OrcaSlicer community Unofficial space for Orca Slicer users to discuss settings, features and tips
  • Does the cost estimator in orca not work? : r BambuLab - Reddit
    ANSWER: I was having the same issue I was a little stumped at first, but after looking at the settings between Orca and Bambu, I noticed there was a "Time Cost" setting in the PRINTER SETUP section in Orca but not Bambu When I set up the printer profile, I had put a value of $10 hr in there
  • Is there a setting in orca equivalent to the combing mode in cura?
    Help I'm encountering an issue with my Neptune 4 Plus printer where the nozzle rubs against the print during infill Many have suggested disabling combing mode to resolve this, but I'm unable to locate a similar setting in Orca Slicer I'm curious if there's indeed such an option available within Orca
  • Speed acceleration : r OrcaSlicer - Reddit
    Orca, on the other hand, shows the acceleration settings by default, and they are always activated and controlled by the slicer Speed and acceleration work together Speed tells you how fast it can go, that's the limit, but acceleration tells you how long it will take to reach that speed in a straight segment
  • r OrcaSlicer - Reddit
    r OrcaSlicer: Unofficial space for Orca Slicer users to discuss settings, features and tips


















中文字典-英文字典  2005-2009