英文字典,中文字典,查询,解释,review.php


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       


安装中文字典英文字典辞典工具!

安装中文字典英文字典辞典工具!










  • Is AUS 10 steel good for knives? - Knifebasics
    The knives made of AUS 10 steel will require frequent sharpening due to less edge retention ability while the ones made of VG-10 can maintain an ideal edge for a longer period of time Both AUS 10 steel and VG-10 steel are stainless steels with high Chromium content
  • Knife Steels Rated by a Metallurgist – Toughness, Edge Retention, and . . .
    The highest edge retention steel was Rex 121 which was at 70 Rc in combination with lots of high hardness vanadium carbides We can predict edge retention of a steel within a relatively narrow band based on hardness and carbide volume
  • lets talk bout aus10a how good or how bad : r knives - Reddit
    Larrin rates the corrosion resistance at 7 9 10, the edge retention at around 480 TCC (just above 440c, just below D2), and the toughness at around 6 ft lbs (pretty low) when hardened to about 60 6 HRC
  • Knife Blade Steels and Facts — WoodWorld of Texas
    440 Stainless Steel: 440(X) Stainless Steel: a higher grade of cutlery steel, with more carbon, allowing for much better edge retention when properly heat-treated It can be hardened to approximately Rockwell 58 hardness, making it one of the hardest stainless steels
  • Aus6 Aus10 Vg10 440c - BladeForums. com
    AUS-10 and VG-10 are very similar They are comparitively hard stainless steels that sharpen pretty easily to fine edges and hold the edges a lot longer than AUS-6 These are good all around choices unless you want to use your knife as a crowbar 440C is in the same class as AUS-10 and VG-10, but sometimes doesn't take as fine an edge
  • Knife Steel EDC Performance Rankings - Spyderco Forums
    There are some differences between each, but combined to save space 420HC had the best edge retention with 108 TRC and is also more corrosion resistant (closer to a 7) AUS-8 8Cr13MoV - 3|5|6|8 - 89 TRC
  • Compare 20 Grades of Knife Steel - ThoughtCo
    These grades of Japanese stainless are comparable to 440A (AUS-6), 440B (AUS-8), and 44C (AUS-10) AUS-6 is softer but tougher than ATS-34 It holds a good edge and is fairly easy to resharpen AUS-8 is tougher but is still easy to sharpen and holds a good edge
  • AUS 10 Steel: The All-Around Performer You Need to Know About - Noblie
    Edge retention: Thanks to high carbon content and the presence of vanadium, which contribute to the steel’s ability to maintain a sharp edge over prolonged use This aspect is crucial for users who require consistent performance without frequent sharpening


















中文字典-英文字典  2005-2009